Galep-5

Assignment for Development, service and mobile component programming. Also be used as a full production programmer.

High-Speed programming

The programming algorithms run on an internal 200 MIPS ARM-9 processor under Embedded Linux. The processor directly controls the pin-drivers via an FPGA, thereby ensuring perfect adaptation of the component to any programming algorithm. The FPGA (user-programmable logic) allows realization of State Machines, UARTs etc. and thus supports time-critical components.

Programming cycle times have been achieved that are very close to minimum possible times specified by any component. The internal 64 MB RAM serves as a data storage area, thus requiring that data only be stored once for programming multiple devices.

 

48 universal pin drivers

Each of the pins can carry the following signals:

• Logical high, adjustable between 1.3V ... 5.0V
• Logical-input, threshold adjustable between 0.5V ... 5.0V
• Three independent programming voltages up to 25V
• Ground
• 3 switchable resistors for pullup and pulldown
• Clock with adjustable rate

 
No power supply required:

GALEP 5 is powered through the USB bus and does not require any additional power supply. The USB current limit of 500mA is maintained. Some old NMOS components and some micro controllers consume more than 500mA so to ensure full USB compatibility, Conitec recommends using the included power supply, or the specified rechargeable batteries (6 x AAA batteries) for such components.

Programming voltages

in 100 mV steps with accuracy threshold 0.5V ... 5.0V.
 

In System Programming (ISP)

The signals for in-system programming can be taken from a
separately available ISP adapter or directly from the 48-pin ZIF socket. The help system provides
information about the wiring of the target system for all supported components.

 

JTAG Support

Delete, program and verify components with JTAG interface (joint test action group, IEEE Std. 1149.1 ).
The following formats are supported:

• SVF-Script in XSVF (Xilinx) format;
• JAM byte code player (ALTERA).

Software

The software is continually updated to implement hundreds of new components as often as
every 2 months, adding thousands of new devices to software yearly. More informations you will find of the follow website to Conitec.  www.conitec.de

GALEP-5 programs all components in DIL sockets up to 48 Pins between 300 … 600 MIL
(i.e. ca. 7,5 up to 16 mm) wide, without requiring additional adapters.

Of course adapters for components with more than 48 pins are also available.

Therefore if you need to program components with a high pin
number frequently, the GALEP-5D model, (with up to 240 pins) may be a more effective solution.

We do note however that all existing GALEP-4 adapters can be used with GALEP-5, for full portability
of your existing Conitec hardware!

Hardware

• 48 pin ZIF socket
• 48 universal pin drivers
• 200 MIPS ARM-9 RISC-Prozessor
• 64 MB RAM
• 8 MB Flash RAM
• FPGA (50K gates, 64Kb RAM)
• USB 2.0 high-speed interface
• 3 linear voltage regulators for internal power supply
• 4 switching regulators for programming voltages
• 2 linear voltage regulators for logic levels and input threshold
• Built-in microcontroller that monitors the internal power supplies
• Built-in microcontroller that monitors the programming voltages
• 8-channel D/A converter
• 16-channel A/D converter

Warranty Term:: 24 Month

Certification: CE, UL